Disclosure: Post includes Amazon Affiliate and direct product links.
Continuing our trend of sucking, we picked up new under-desk vacuums and have to say–this is our current under-desk vacuum of choice, and includes a mounting plate that lets us stick it just about everywhere.
It’s not a full-power vacuum like our Rigid vac (which we’ll review, and was briefly mentioned in our Print: Vacuum Dust Collector for Wall Drilling post) but for our main desks (e.g., computers, some soldering, and an inappropriate amount of sanding), it’s pretty great.
It’s a one-gallon, 1HP, 1.25″ hose (but as noted below, it has a long taper, so some accessories might not fit without tweaking) and takes a filter bag if you’re not using it for wet stuff.
It’s small, so very small. It ships with a bag installed–so while it’s totally a wet/dry vacuum, go ahead and remove that bag before resolving your Pepsi Syndrome with this little guy.
It ships with only flat and crevice tools, which is mostly-okay, although a few more tools would have been nice. We’ve also hooked it up to a number of micro-vacuum attachments with a 3d-printed adapter (yup, we’ll post about that as well) and sort-of works out-of-the-box with the afore-mentioned vacuum dust collector attachment–but the stock hose tapers from ~1.21″ to >1.25″ so it’s a bit floppy. We’ll have to modify the attachment to have a longer hose attachment area (or just cut the stock hose). It’s powerful enough to stick the DC attachment to the wall even with the non-fitting host diameter, so it’s more than sufficient for our desk vacuum needs.
(In fairness, when we’ve discussed this with other folks, they’re unsure why a desk needs a dedicated vacuum. IT’S OBVIOUS, OKAY????)
There’s also a convenient handle that folds on top–it’s not a nice flat surface like the Rigid (boo, we like things that stack) but it’s handy. The only thing we find lacking are mount points for the tools on the vacuum itself: there’s a bracket that (apparently?) is meant to mount on the wall next to the vacuum–we might repurpose it and stick it on to the vacuum itself, or just print something we can epoxy on the side so we don’t have to screw into the canister.
At ~$34 on Amazon we grabbed four, two of which are already mounted and in consistent use. It’s micro, it’s a vacuum, it’s really convenient. It became even more convenient with a quick remote switch so all we do is grab the hose and start sucking.